Yamaha YXZ Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Just put a new clutch in the clutch wasn’t engaging figured out it was the ball bearing put it back in road it for about 30 minutes an the clutch is not engaging again tryin to get this done before Saturday
 

·
Registered
Joined
·
931 Posts
I assume that you mean the clutch will not disengage. Maybe operating the clutch without the ball has caused the slave cylinder piston to move out too far and it finally popped past the seal. How is the clutch master cylinder fluid level?
 
  • Like
Reactions: WWARt
1 - 2 of 2 Posts
Top