[Tboyd]

So far, loving the new Super ATV flip windshield! Took it for a test drive, given it is 40°, it did great. I noticed the heat coming from the radiator (2020 SS) and thought 'hey, this is nice!'. But... should I be worried about not enough air getting to the radiator? Thoughts? Also put on some decent amazon mirrors. Not too bad for the price...

 

[23824]

It will work just fine my windshield does not open and it works great with no problems.

 

[Tboyd]

Good deal. Thank you!

 

[Jeffawats]

I have the same windshield and have never had a problem with air flow.FYI no back window or side windows either

 

[sandman89]

Get the fan reverse pigtails and it's like getting a almost free heater. Add a fan override switch and you can have heat whenever you want. I love mine all winter.

YAMAHA YXZ 1000 COOLING FAN REVERSE KIT

This kit allows you to reverse the radiator fans on your 2019'+ YXZ 1000 to force warm air into the cab. OEM connections, 16ga wire & soldered connections. Kit includes 2 wiring harnesses for you dual fan setup. Simply unplug your stock fan connections and plug these in-line.

www.dzmotorsportsllc.com

 

[RobBeck]

Same windshield here. I even reversed the fans using the little harnesses for the cold, no issues aside for fogging when going through water.

 

[leadmic]

Or do this.

This enables the fans to blow hot air into the cab for a heater with the press of a switch. With the switch in the off position, the fans return to the factory direction. Someone was asking for this earlier and I just got around to doing it.
All positive wires are shown in red (except the positive lavender factory wires) All negative wires are shown in black (including the factory negative wires).
Parts required: Four waterproof Bosh relays, switch, two fuses and holders, two factory fan connectors (two male and two female), wiring colors of your choosing. All wires to terminals 85 and 86 need to be 22 gauge or larger. All other wires need to be 12 gauge or larger.

 

[RobBeck]

Or do this.

This enables the fans to blow hot air into the cab for a heater with the press of a switch. With the switch in the off position, the fans return to the factory direction. Someone was asking for this earlier and I just got around to doing it.
All positive wires are shown in red (except the positive lavender factory wires) All negative wires are shown in black (including the factory negative wires).
Parts required: Four waterproof Bosh relays, switch, two fuses and holders, two factory fan connectors (two male and two female), wiring colors of your choosing. All wires to terminals 85 and 86 need to be 22 gauge or larger. All other wires need to be 12 gauge or larger.

I wish someone would make this into a little DIY package using the most ideal marine components, with as much pre-wired as possible. I'd not care if the switch was mounted in the bed, behind driver, even on the under carriage. But definitely would be nice to not have to add/remove hardness for the fan switching.

 

[NeboYxz1000XTR]

I have this windshield in front only no rear my temps run right around 195-200 never see higher than 210. Is this about normal for you guys as well. I just installed march 22nd my first ride out today this is what I experienced. 70 degrees outside temp