Yamaha YXZ Forums banner

1 - 11 of 11 Posts

·
Registered
Joined
·
1,232 Posts
There is one from someone else too... UTVinc I believe.

I will probably just add one of these, and then cut the top of the OEM cage and add a metal roof. To make it flat on top.
 

·
Registered
Joined
·
1,764 Posts

·
Registered
Joined
·
582 Posts
Discussion Starter · #11 ·
I went this way instead because it looks like it will surely fit.
Yamaha YXZ 1000 Bolt-on Front Intrusion Bar

They shipped overnight for no charge either! Ill let you know how it goes.
Ok, it will work with the factory full windshield but will require considerable trimming of the ugly plastic panel they have us use. I was going to go for it but then realized adding water to the radiator or accessing the electrical bay up front would be way more of a pain in the ass then I want to deal with. You would have to take intrusion bar loose so you could remove the plastic panel. The way I'm set now it will always have a three or four inch gap on the bottom of the windscreen, I'm ok with that as I'm not mudding. For now I added rubber door bumpers so the windscreen can be lashed down to the intrusion bar using two small bunnies looped through the existing holes in screen. I'll post final pics when I get back from vacation next week.

20151217_170133.jpg
20151217_170326.jpg
 
1 - 11 of 11 Posts
Top